Suitable for a wide range of sign panels such as Dibond, Wood, Acrylic, Polycarbonate, Cardboard honeycomb or Toughened glass in thickness of 6mm up to 26mm up to 1200mm high. Your display board can be single or a double sided advertisement.The wing shaped silver anodised aluminium profile has two sections that clamp onto you panel as you turn knob on the underside of the sign holder. The base has grey end clamps to finish it off.
The hardware comprises of 2 large wings that are assembled together with an easy to use clamp. Your graphics board is inserted in between the two wings and clamped by simply tightening the knob on the underside of the display stand. Custom panels can be made which include literature racks of poster holders
Panels can be made to the exact width of the sign holder base or the can extend beyond the base so for example you can use a 400mm wide panel with a 300mm base. You can also use two bases so you could use two 100mm deltas to support a 600mm wide display. The overall depth of the base depends on the thickness of the panel you use but is about 400mm. The bottom of you panel will be raised about 145mm off the floor.
The maximum height depends on the material and width of the panel as well as the base width you choose. And where the base will be used. Indoors in a low traffic area you could go up to a height of 1600mm although 1200m is more common. The delta can be used for temporary signage outdoor in a sheltered location a much shorter panel is recommended.
Many different panels material are available and specials can be created for example a wooden panel may be used that has a snap shut poster frame attached or two sheets of toughened glass could be used to sandwich a graphic between them. Please call one of our display experts to discuss your requirements.